install

Hi, I removed my side fairing today to do something and no matter what I do I can't seem to get it all lined up in order to refit it. The main bit that won't line up is on the inside where the push clips go. I still need to remove the other fairing so I'll have to go through it all again aswell...

Hi, I am trying to figure out if I can install the Andreani cartridges myself (I have the Hynes manual and I stare at the cartridges in the bench for few weeks now). Once I disassemble to the forks from the bike: 1. Right fork - looks like if I unscrew the top cap, open the lower screw at the...

So I brought my bike to a shop I’m pretty close with and they were helping/showing me how to install my full Akra correctly but I noticed a couple things that seemed off to me… 1. They used Blue loctite (which is fine I think just no video I’ve seen uses it) 2. When using the torque wrench I...

Hello everyone! Today I attempted to install some evo1 foldable aftermarket levers on my 2022 CBR650R was going all well and good until I was unable to get the sleeve/bush out of the old lever to transfer into the aftermarket evo1s. so I was wondering if anyone knew the size of the bush/sleeve...

How to align correctly cam chain, I have been reading service manual but, I guess I have it 180 degrees off？

Hello everyone! I just got my last christmas gift in the mail. A little present for the 650. I got these off twisted throttle.com for about 140$ after shipping. I ordered them to help with the cold wind on my hands during the winter. Install was brief and painless. I will mention that this...

Gday guys, I’ve had the bike in the shed over a few months chipping away at modding it! Unfortunately I’ve got the fairings off and installed a fresh Austin Racing pipe but I’ve been busy at work (and lazy) and didn’t get back around to getting the fairings back on before I forgot how I got them...

Do these R&G bar end sliders really install in a matter of seconds? From my research here getting the bar end caps are a major difficulty.. my factory one is a little scratched touch the wall by accident so thought I would replace them with these...

Hi all New to the site Cbr650r owner I'm installing a dash cam Can someone help I'm looking for the 12v wire that's controlled by the key so dashcam comes on and off by ignition The dash cam is vsysto b2f

Hi everyone, I just bought a Pitbull 8mm Spool Kit which revzilla says fits on my bike but I do not see any hole where the rear spools could fit. Is there an adapter or something I have to buy to install these spools? https://www.revzilla.com/motorcycle/pit-bull-8mm-spool-kit Thanks

Not sure if this has been posted but it's a useful link to install instructions for a lot of Honda accessories. Ironically the CB650F belly cowl is not on there, I'll work it out....:muted: Enjoy. http://cssportal.css-club.net/honda/MCA/start.asp?GROUP=oth