cam chain install ?

[enshiu]

How to align correctly cam chain, I have been reading service manual but, I guess I have it 180 degrees off？

 

[Brammers]

The process in the manual is right. I've used it when putting new shims on the valves.

What's your exact process / problem?

J

 

[enshiu]

it doesnt start, keeos backfiring which page on the service manual is it?

 

[Brammers]

Can't recall right now, will be in the engine chapter. Have a look under "c" in the index.

J

 

[enshiu]

Is this the correct procedure?

 

[Brammers]

Yes, that's the one I followed.

J

 

[enshiu]

ok

 

[enshiu]

Thanks it works

 

[enshiu]

I did intake cam reversed so it was losing compression instead of building compression.

Camgear bolts M7 = 20Nm
Chain guide tensioner M6 = 10Nm
Crankshaft bolt M10 = 83Nm

Valve cover M6 = 10Nm

Clutch cover case M6 = 10Nm
Clutch cover for crank bolt Case = 18Nm

Injector rail M6 10Nm

Airbox inlet bolts M6 8Nm
Airbox screws JIS 2Nm

Fuel tank bolts M6 10Nm
Spark plugs M14 15Nm

Igniter bolts M6 10Nm
Coilpack bolts M6 10Nm

Fairing bolts M4 2Nm
M5 5Nm
M6 8Nm

Thermostat bolts M6 10Nm
Waterhose rear block bolts M6 10Nm
Watertemp. sender M10 17Nm