rear brake

  1. P

    All 650's Rear Caliper Rubbing

    Hi All, I recently had to fit a new tyre are picking up a puncture. I made sure to get the spacers the correct way around and torqued the nut up to the recommended settings. Prior to the new tyre everything was fine with no issues. My next ride out with the new tyre the ABS light started...
  2. D

    CBR650R Rear brake

    Hi does anyone else think the rear brake feels like it's does nothing except when your doing about 10 kph or under.
  3. Fram7

    CB650R REAR BRAKE

    Hi guys, IS IT NORMAL THAT THE CB650R REQUIRES A LOT OF MOVEMENT FOR THE REAR BRAKE TO ENGAGE? IS THIS ON PURPOSE? My rear brake has to be pressed a lot before being effective. If I push fully at low speed it blocks the wheel so it is working fine. I am new to my CB650R that only has 1700...
  4. Fram7

    CB650R DAMAGED PAINT IN REAR BRAKE DISC

    Hi Guys, My CB650R has the black paint on the rear brake damaged. It seems the previous owner used some chemical and the paint has bubble away in same places. How should I fix it? Clearly a new disc will do it but it is a lot of work to fit? I am familiar with these type of work and not...
  5. R

    Accidentally dropped bike, mystery fluid and change in rear brake feel resulted

    So I finally did it, forgot to remove my wheel lock before starting off and of course stalled and dumped the bike. Luckily this was in my garage with a cement floor so it didn't damage the paint too badly. The main contact point was the engine cover which now has a small scrape. The weird thing...
  6. M

    All 650's Rear brake light switch adjustment.

    Hi folks, I am following the user manual to adjust the engagment of the brake light when activating the rear brake as I feel its way out of spec. Is there any special technique to doing this? I am rotating the bolt in the required direction but it is not making a difference. As it is hidden...
  7. Sonx

    All 650's Rear Brake Rotor Scoring After Installing EBC Double-H Sintered Pads?

    I had OEM pads on my rear tire and I just installed EBC Sintered Double-H Pads and I am trying to find out of this is normal. I took my bike out for its first ride and I can "feel" it scoring the rear rotor on initial contact. When riding and I apply pressure to the rear brake, it feels a little...
  8. Doohanisthegoat

    All 650's Empty rear brake reservoir.

    For some reason the rear brake reservoir on my bike is completely empty. I don't often use the rear brake so was wondering what I should look for to see what caused it?
  9. P

    CBR650F Rear brake feel

    2015 CBR650F non-abs. Just got the bike a few weeks ago. 5300 miles on it. Rear brake seems really weak and has a weird feel to it. Not sure since I'm new to the bike but it just doesn't seem right to me. 1/4 pedal does about nothing, 1/2 pedal start to get some slowing, then 3/4 pedal the pedal...
  10. rich_p

    CBR650R Rear brake/footrest circlip

    Hi all, Quick question. I have recently had all my footrests anodised on my CBR650R. As part of the dismantling process, I removed a circlip and washer holding the rear brake pivot to the footrest (picture attached) - the units are also bolted together. When I tried to reassemble, the circlip...
  11. H

    Brake Light Wiring

    just trying to wire up a new brake light but just wondering what wire is positive, negative and ground.
  12. rustyeyed

    All 650's HEL Stainless Steel Braided Lines (DIY Installation) - REAR LINES

    REAR BRAKE LINES: HEL Rear Lines were installed and brake calipers and pads serviced. (obvious steps not shown) DIFFICULTY: Intermediate PATIENCE REQUIREMENT: Expert INVENTORY: Rachet 8mm spanner 8mm socket 10mm spanner 12mm socket Torque wrench HEL rear brake lines HEL bolt (each bolt comes...
Top Bottom