sensor

Ive recently tried to replace my stock exhaust with a black widow full exhaust system. I unfortunately snapped the old o2 sensor but have one ordered and coming in a weeks or so. I have a plug for the new exhaust and wanted to ask would it damage my bike if I rode around without the sensor for...

Hello, while installing the OEM quickshifter for my CB650R I ran into some confusion. I found two official Honda installation manuals with 2 different measurements: 175mm and 5.11 inches, for the gear change harness protector on the sensor wire. Which one should I follow? (See photos) Thanks...

I'm currently installing my Akrapovic exhaust on my 2016 CBR 650 F and noticed that nobody on the internet (install videos and I couldn't find a post here either) talks about the copper crush washer on the O2 / Lambda sensor. Not even the Akrapovic manual or the service manual mention it. Is...

Hey guys, I picked up a 2014 cbr650f and I have been riding it for a while. It had an ABS light on when I bought it (which i was aware of) and my understanding is that the abs system has an issue and when the light is always on the brakes work normally, just without abs. I took the bike in to...

Hi all, CB650R 2020. I recently had an error code for TPS but that's gone away and now replaced with the P0132 - Bank 1 Sensor 1. Where is this located and how can I amend? Error has rencently appeared when swapping out my relay for indicators as I had to replace the rear one as it snapped...

Since I got my ‘14 cbr650fa I’ve had lots of idle issues. At first it would idle all over the place up to 3k, I replaced cracked hoses leading to map sensor and it dropped down to idling at 2k. When map is unplugged and running on preset airflow it idles perfectly and has 0 issues. I replace the...

Good evening, David from South of France. i have a cbr 650 fa 2014 which is about 78000km running on ethanol with a kit The bikes runs on ethanol for over 70000kms. Ethanol or normal gas is the same the bikes doesn t run well I has never been running well and I have noticed the vaccum hose...

Hey, So I dismantled my bike lately to fix some issues and I am trying to reassemble it however I am facing some issues into locating the bank angle sensor.... Can someone help me find it please ?

I'm looking to find out what the thread dimensions are for the o2 sensor so I can have the place it screws into re-threaded

My apologies if this is a repetitive thread, but I couldn't seem to find the information I'm looking for. If this is the case, please point me in the right direction. My 02 sensor has gone, and obviously I could order the stock part, but I was hoping there might be another brand/model that I...

So I've found some threads from years ago but they all were incomplete without any real solution discussed. I had my CB derestricted with an ECU flash. Bike runs amazing and love it - but the traction control light is on. Done - trumpets, air filter, ECU flash; stock exhaust. I plugged in the...

Hi everyone, I have encountered a problem while fitting a black widow system to my 2024 cbr650r. I’ve just noticed that the bike has 2 sensors going into the exhaust. The o2 sensor on the right side of the bike that goes into the pipe but there’s another sensor on the left side going into the...

I'm going to drive home (40 km), but the engine light is on because I managed to damage the oxygen sensor. Can I drive home, or is it harmful to the engine? I have installed an aftermarket exhaust system. If the oxygen sensor is not working, does the system run rich to protect internal components?

Hi all, just plugged my bike in after a engine light. Showed up with o2 sensors errors. With a new, oem part costing 440£ that's bizarre. Is there a suitable alternative?

Hello all, This is my first time posting here so apologies if I mess something up in the post. The bike is a 2016 CBR650F with ~23,000 miles with an akrapovic exhaust, besides that I believe it is stock. I got the bike this spring and went about 500 miles before having any issues. My issue is...

How to find out VS Sensor pinout? I have found so far in the WM that the sensor is found but, which wire in the plug does what? Is P/G > P colour the speed signal to instrument cluster?

I'm currently tuning the CB650R as the power commander doesn't work on 2021 euro 5 model upwards I started to do some research and came to the conclusion this is a much better solution than the 1 size fits all solution dynojet provides as it actually tunes your bike... Just thought I let you all...

Or did it shift to ABS sensor for ABS models? Couldn't find anything concrete with site search or goog search.

Can anyone help me identify / show me the actual part number of throttle position sensor for 2019 650R , bought Keihin jt7h from ebay and install it myself, at closed throttle and 0.5 volts the bike was idling crazy at about 4000rpm. but after a slight twist at 1.1volt approx, idling was just...

So I got my bike back last week, i got myself a 02 sensor eliminator, I'm trying to find where it plugs into, I've looked everywhere for a answer but I cannot find a solution. Thank you