Replacing foot peg confusion

[jerzy_bondov]

After a mishap (not mine, I promise!) I need to replace the foot peg on the right side of the bike - essentially part number 12 here has snapped off (and see pic):
https://www.babbittsonline.com/oemparts/a/hon/5989f1fe87a86612c4eaa1e7/step

Do you replace the whole assembly, as Babbits just seem to sell all the individual bits? Or is it in fact a simple pop out the pin and replace job?

Thanks!

 

[Goblin]

As far as I know, parts with their own number can be ordered separately. But contact your local dealer to be sure

 

[Brammers]

Pop the pin and replace.

It's a two minute job.

Beware the spring loaded ball bearing that's in there!

J

 

[Brammers]

Actually I think you've lost that. You'll also need a new ball and spring, otherwise the peg will flop down all the time.

 

[coreyfreeman]

Actually I think you've lost that. You'll also need a new ball and spring, otherwise the peg will flop down all the time.

only the pillion rests use the little spring, ball and lock plate, rear sets just have that simple spring holding it down

 

[Brammers]

My bad. Need new glasses!

 

[jerzy_bondov]

Thanks all!