Recent content by kylehondarider

Thanks! I'm pretty much fully recovered now, the bike turned out a lot better than I did. I lost traction in a corner and high-sided, broke my right elbow and 3 other places in my arm and had surgery. The bike was all cosmetics pretty much. I put new tires on it and I've been back riding the...

Hey sorry I've been inactive, I crashed the bike in Dec 😢 but damage was pretty minor. I have not resolved the issue but recently talked to a mechanic that does dyno tuning and he made it sound like that should fix the issue. I plan to get it tuned before summer. Regarding fuel questions in the...

I seem to be having a similar issue but have not found a solution- here's my thread- https://650f.bike/threads/breaking-up-at-7k-rpm.2823/post-30811

Thanks- Yes, I've been doing all the work myself so far and have had the tank off and fuel pump out 5+ times. I may take a video for reference, not sure how well it will turn out with wind noise etc. I think it's supposed to rain the next few days however. I do have a set of new plugs I haven't...

I purchased the bike with 1200 miles and the Akra was already installed, apparently by a dealership. So I assume it was installed correctly. I've not ridden the bike with stock exhaust at all. I don't know if the problem has been there the whole time I've owned it or not. I noticed it first...

But wouldn't bad coil packs/plug leads cause problems throughout the RPM range? Intermittent behavior? The motorcycle runs good in all other conditions, only issue is WOT above 7000 RPM

Compared the plug to a photo chart and it was exactly where it needed to be. Bike has 4,000 miles. I'll need to see if I can get a pressure gauge or send it to a mechanic to check that.

So problem I'm having is at wide open throttle the motorcycle runs like crap above 7000 RPM. I spoke with a mechanic and he suspected a fuel pressure issue so I've tried a few things I'll explain below but I believe it's a fuel map or something else. The behavior is very much ON/OFF dependent on...

Well, I finally got around to designing this! Here's the first revision. No additional hardware required.

There are different types of material, some of which are more resistant to UV. As far as quality, there will be some noticeable lines/layers at a close distance. I'd design it in a way that it would be about as strong as OEM. I tore apart the OEM fender this morning to look at mounts etc. and it...

Hey guys just bought a CBR650F and I'm loving it :) I was curious if anyone would be interested in purchasing 3D printed fender eliminator kits? I have a printer and may design a kit for myself and also make it available for purchase. I'm thinking price point would be around $20. Kyle