All 650's Paddock stand bobbin size

[baloo2650]

Powerstands Racing. I bought it 4 years ago from Cycle Gear, on sale. Doesn’t look like they carry the brand anymore, but it looks like they sell direct. The rubber blocks are very study, and the square ones work well on the 650F swing arm, despite the fact that the two sides are not the same height.

PSR-USA

Racing Inspired Built For Performance

psr-usa.com

Cool, Thanks!

 

[szyowe112]

my bike almost drop when I put the rear tire on the ground from a pit stand, the tire hit the ground so hard as it bounces back and almost fall to the other side
the bike is so heavy comparing to my cbr300r

 

[SamT94]

front or rear? I’m running these on the rear and they were direct bolt-on:

R&G Axle Sliders Swingarm Spools | Select Honda Models

In case anybody is still looking for them, the new link is this...

Cotton Reels (Offset) for Honda CBR650F, CB650F '14- , Africa Twin CRF1000L '16-, Africa Twin Adven

Cotton Reels (Offset) for Honda CBR650F, CB650F '14- , Africa Twin CRF1000L '16-, Africa Twin Adventure Sports '18-, CB650R '19- & CBR650R '19-

www.rg-racing.com

 

[Glamav]

What about these? I have them allready, still searching for free time to put them on.

 

[User28]

I was looking for the same but decided to pay the extra and get an ABBA stand , only takes 2 min and she's up no issues getting the wheel off it lifts the back slightly higher than my paddock stand which is good no need to bend down so far, and to lift the front i ethier get my son to push down on the seat or place a trolly jack under the sump and lift from there , practice makes perfect

 

[wke002]

i got my rear paddock stand and now looking at front. which of these 2 would be ideal. intend to lift both tires up for few weeks storage each time, as afraid with side stand, my tires might cause a dent.

 

[miweber929]

Either work fine but any “flat spots” your tire may get from sitting will be gone once the tire heats up. I wouldn’t worry about it.

 

[Brian C.]

I have the bottom one, and it works perfectly for me. Not sure the Headstock stand (The top one) would fit with the fairing in place? I would play it safe and go for the Bottom one myself.

 

[miweber929]

Not sure the Headstock stand (The top one) would fit with the fairing in place?

They do with the correct pin.

 

[wke002]

My front bobbin arrived and got the front standing. I find the front wheel wont turn as freely as i expected. Each hand turn, it rotate only like a quarter of turn, is that normal. Advice appreciated.

 

[miweber929]

My front bobbin arrived and got the front standing. I find the front wheel wont turn as freely as i expected. Each hand turn, it rotate only like a quarter of turn, is that normal. Advice appreciated.

Should be almost a full turn minimum.

Remove your calipers and see if it’s the brakes dragging. If it’s dragging with no calipers, it’s the axle setup. If not, push the pads back in a bit on one caliper, install it, then the other and see if it’s one caliper or the other. Then apply the brakes and see what you get.

Guessing here but most likely a sticking caliper puck.

 

[wke002]

Am guessing its brake pad. Will find time to remove and might as well clean the calipers and all. Tks.

 

[Ericatcse]

thinking of getting the one to lift the head stock any idea what size pin is needed for the 2020 CB 650r neo?