Recent content by Apex11

  1. A

    CB650R DAMAGED PAINT IN REAR BRAKE DISC

    Brake fluid will cause that. That's why it needs to be cleaned off immediately. Will need to be repainted.
  2. A

    CBR650F How long should a cold start take?

    What is the ambient temp in your area? What oil you running? Maybe to thick of oil for cold temps causing slow crank over? Just a thought.
  3. A

    CB650R What would "you"do?

    You can pick up a kit on Amazon.
  4. A

    CB650R What would "you"do?

    I just used plastic body panel clips. Cost almost nothing.
  5. A

    CBR650R Engine management light, torque light and engine limit

    Ok so the standard is there for high and low voltage. Hope this helps!
  6. A

    CBR650R Engine management light, torque light and engine limit

    Shows how to check for high and low voltage. I don't see what resistance to set to . Taken from a '21 service manual. First time really using my manual, bike is new.
  7. A

    CBR650R Engine management light, torque light and engine limit

    Loosen sensor (on bike). You can now turn sensor to change resistance. Adjust until proper resistance is reading. If resistance can't be reached replace with new sensor and adjust for resistance.
  8. A

    CBR650R Engine management light, torque light and engine limit

    TPS must measure a specific resistance. Check resistance and try to adjust. If resistance can't be reached ( as per service manual) TPS needs to be replaced.
Top Bottom